Elenco 100kHz Function Generator in Kit Form Bedienungsanleitung

FUNCTION GENERATOR KITMODEL FG-500KAssembly and Instruction ManualELENCO®Copyright © 2013 by Elenco®Electronics, Inc. All rights reserved.

-9-! Remove the backing from each rubber foot andplace them in the locations shown in Figure M.! Assemble the top and bottom case sections andf

-10-TROUBLESHOOTING GUIDEA) NO SINE/TRIANGLE OR SQUARE WAVE OUTPUT1) Check the soldering on switch S3.2) Check battery and battery snap.3) Check the s

-11-FUNCTIONAL DESCRIPTIONThe FG-500 is a function generator integrated circuit capable of producing high quality sine, triangle, andsq

-12-CONTROLSRANGE SWITCHESSix ranges of frequency are provided by the range switch as shown in Table 1.Table 1POSITION TYPICAL FREQUENCY RANGE1 1Hz -

SCHEMATIC DIAGRAM-13-Answers: 1) XR-2206; 2) A Voltage Controlled Oscillator, An Analog Multiplier and Sine Shaper, Unity Gain BufferAmplifier and A S

Space War GunK-10Rapid fire or single shot with 2flashing LEDs.0-15V Power SupplyK-11A low-cost way tosupply voltage toelectronicgames, etc.

ELENCO®150 Carpenter AvenueWheeling, IL 60090(847) 541-3800Website: www.elenco.come-mail: [email protected]

PARTS LISTIf you are a student, and any parts are missing or damaged, please see instructor or bookstore.If you purchased this kit from a distributor,

-2-PARTS VERIFICATIONBefore beginning the assembly process, familiarize yourself with the components and this instruction book.Verify tha

-3-INTRODUCTIONIDENTIFYING CAPACITOR VALUESCapacitors will be identified by their capacitance value in pF (picofarads), nF (nanofarads) o

-4-CONSTRUCTIONSolderSoldering IronFoilSolderSoldering IronFoilComponent LeadSoldering IronCircuit BoardFoilRosinSoldering iron positionedincorrectl

-5-Figure BBend the capacitor over beforesoldering.ASSEMBLE COMPONENTS TO THE PC BOARDCare must be given to identifying the proper components and

Figure Ea Figure EbMount the pot down flush with the PCboard. Solder and cut off excess leads.ASSEMBLE COMPONE

-7-WIRING (See Figure J)! Solder the wire from hole J1 on the PC board tothe first yellow binding post as shown.! Solder the wire from hole J2 on the

-8-FINAL ASSEMBLYFigure K! Fit the PC board assembly into the topcase, making sure that all switches andpots come through the holes