Elenco Digital Mulitmeter Kit Bedienungsanleitung PDF herunterladen (Seite 8)

r Put the bearings into two opposite indents in the case top as shown in Figure K.

r Place the six slide contactors on the selector knobs as shown in Figure K.

r Place the selector knob into the case top so that the springs fit over the ball bearings as shown in Figure K.

r Place the PC board over the selector knob. Be sure that the 8-pin socket slides into its hole. Then fasten the

PC•board with three 6mm screws as shown in Figure K.

r Insert the 0.5A, 250V fuse into the fuse clips. Your fuse may be unmarked.

r Peel the backing off of the front label and place it on the case top.

r Connect a 9V battery to the battery snap.

-7-

Figure K

PC•Board

6mm Screws

Slide Contactor

Rib

Close-up View

Bearings

Battery Compartment

Case Top

Selector Knob

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Keine Kommentare

Elenco Digital Mulitmeter Kit Bedienungsanleitung Seite 8