Elenco Diode/Transistor Tester Kit Bedienungsanleitung

TRANSISTOR - DIODE TESTER KITMODEL DT-100KAssembly and Instruction ManualCopyright © 2014, 1988 by ELENCO®All rights reserved. Revised 2014

-9-CHECKING OUT YOUR TRANSISTOR/DIODE TESTERThe following is a simple procedure for testing your DT-100. If the tests fail, refer to the troubleshooti

-10-Note the schematic diagram on the back cover ofthis manual. The test transistor in this circuit is aNPN. Adjusting the variable

ELENCO®150 Carpenter Avenue • Wheeling, IL 60090(847) 541-3800 • www.elenco.com • e-mail: [email protected]

-1-Qty. Description Part #! 1 PC board 511100! 1 Switch push button 540001with 1/4” nut and washer! 2 Switch DPDT 541111! 1 Battery snap 590098! 1 Bat

-2-PARTS VERIFICATIONBefore beginning the assembly process, familiarize yourself with the components and this instruction book.Verify tha

-3-CONSTRUCTIONSolderSoldering IronFoilSolderSoldering IronFoilComponent LeadSoldering IronCircuit BoardFoilRosinSoldering iron positionedincorrectl

ASSEMBLE THE FOLLOWING COMPONENTS TO THE PC BOARDR4 - 330kΩ Resistor(org-org-yel-gold)R1 - 330Ω Resistor(org-org-brn-gold)R3 - 33kΩ ResistorR2 - 33kΩ

-5-ASSEMBLE THE FOLLOWING COMPONENTS TO THE PC BOARDQ1 - 2N3904 Transistor(see Figure B)C1 - 10µF Electrolytic(see Figure C)Q5 - MPS A70 Transistor(se

-6-FINAL ASSEMBLY! Peel the backing off of the front label and carefullyadhere it to the top case, aligning the holes whiledoing so, as shown in Figur

-7-! Strip the insulation off both ends of the blue wireto expose 1/4” of bare wire. Solder one end to thehole on the copper side of the PC bo

-8-! Remove the colored boots from the four alligatorclips (to remove the boots, clip the alligator cliponto a pencil and slide the boot